Email Sign-Up
Close [X]


Receive information about new products and educational opportunities, as well as, exclusive offers only available to subscribers!

                                       To Order 1-800-542-9297
Biofreeze Professional Spring Sale
Go Back Measuring Devices
Analagraph Recorder For Nervo-Scope® ETS-9A
Zoom zoom reset
Analagraph Recorder For Nervo-Scope® ETS-9A
Alternative Views
  • Analagraph Recorder For Nervo-Scope® ETS-9A
  • Analagraph Recorder For Nervo-Scope® ETS-9A


Analagraph® Recorder For Nervo-Scope® ETS-9A

# 746 0106
Rate this product

Electronic Development Labs, Inc. Analagraph® Recorder For Nervo-Scope® ETS-9A

(Photo shown is with ETS-9A sold separately)

Analagraph® Recorder

This product when used in conjunction with the Nervo-Scope® ETS-9A (See 740 5021), provides a permanent record to log and chart the amount of existing heat differences indicated from your Nervo-Scope® readings. The Analagraph® Recorder is a valuable and efficient tool in documenting patient assessments and providing a pattern reference for pre/post check of patients. This information indicates any change of reading, thus establishing a pattern which may assist in determining the frequency of adjustments. Easy to use and operate, the Analagraph® Recorder has been trusted for over 50 years in the Chiropractic community.


Power Input: 120Vac @ 60Hz, 1A
Overload Protection: 3 AG, 250V slo-blow glass body fuse (rear panel)
Ambient Operating Range: 32° to 140° F
Relative Humidity (Max): 10% to 90% non-condensing
Recorder Resolution: 0.02° F
Power Consumption: Recorder - 5 watts @ 0.3 amps on recording mode. 1/2 watt on standby
Printing Method : Direct thermal
Print Resolution: 200 x 800 DPI
Graph Speed Rate: Low: 6 inches per minute (2.5 mm sec.) High: 9 inches per minute ( 3.75 mm sec.)
Graph Paper Type: Thermal activation
Graph Paper Size: 2 inch wide roll x 100 feet long
Graph Paper Thickness: 0.0025"
Graph Grid Size: 0.195" squares x 8 horizontally x continuous vertically
Switching Power: On/Off rocker switch on rear panel
Graph On/Off : Starts/Stops thermal graphing
Time Marker: Automatic horizontal dashed lines every 3 vertical grid squares
Manual Marker: Allows manual placement of horizontal dashed lines at any vertical interval
High/Low Speed: Sets graph paper speed rate
Audible Sound: Beep occurs for "graph on", "time marker"& "manual marker" intervals
Green Light Indicator: For "graph on" (active)
Red Light Indicator: For "graph off" (standby)
ETS-7/ETS-8 Input Socket: Accepts coil cord, linking Nervo-Scope to Analagraph
Coil Cord: 6 ft. (expandable to 12 ft.) 6 wire pickup
Case: High impact black ABS with handle - powder coated front/rear panels
Size: 8.5" width x 6.4" height x 9.2" deep - not including handle
Weight: 5 lbs.